Megasun Solar Power Water Heaters - Manufacturers of Solar Pool Heating Systems in Greece and Europe |
| 2. ASSEMBLY DIAGRAM OF THE SUPPORT BASE ON A FLAT SURFACE |
ASSEMBLY INSTRUCTIONS
Before choosing the location and the installation point, ensure that it is not shaded by any obstacle (trees, buildings etc., see obstacle diagram).
The same support base is used for either sloping or flat surfaces.
Connect the plates A, B, C, D, U and Z by screwing them tight as shown in the drawings.
For models 260 and 300, screw also the plates F. Screw gently the bottom plate E on the plates B. |
Support base for 200, 260 & 300 (with 2 collectors)
click on grey-outlined areas to zoom in |
Attention
The top plate E is adjusted after the placement of the collectors.
|
Plumb the support base on the flat surface's level. Place the collector(s), on the support base and then screw it with the moly plugs and the screw nuts on the concrete, according to your country's regulations.
|
Support base for 120, 160 & 200 (with 1 collector)
click on grey-outlined area to zoom in |
